AARON Speakers - Quality Design and Performance

Our speakers sound the way your customers wish them to sound

Old fashion built quality
Aaron loudspeakers are built to last even under less than ideal circumstances. Lets summarise some of the major reasons.

The cabinets are made of special fibre board
Not only is this material the best acoustically but its not damaged by water. 

Cladding is laminated with epoxy glue
As a result the cladding will not shrink or peel off as is often seen with other speakers especially when they get old. 

All structural glue joints are done with P.V.A
Although the process takes longer it means a much stronger bond even under extreme heat.

The cross-over circuits are built to last
They are hard wired by hand employing air wound inductors, etched formed foil capacitors and wire wound resistors. As a result you can expect low distortion and circuit stability even at very high power input levels. Naturally we use only quality components that will retain their correct values indefinitely.

Cone surrounds are made of impregnated cloth
Therefore our speaker surrounds don't have the common problem of perishing or cracking.

High power input tolerance
One of the banes of all Hi Fi stores is the constant fight with customers with regard to blown speakers. The single main cause is that most speakers on the market are not deigned for rooms larger than 3m by 4m. The average Australian living or family room is larger than that. So often, the speakers are being played louder than is realised just to obtain what the customer considers is a realistic sound level. We have taken measures to solve this problem by using in all drivers, large high temperature voice coils and two part epoxy glues.

Superior quality control
Every speaker made at our factory is thoroughly checked by our computer controlled quality control section. We have a higher equipment level is this section than most of our competitors have in their laboratory. Not only does this eliminate warranty headaches for you the dealer but you can rely on absolute consistency of performance and quality from us.

Consistent first class cabinet finish
Because we have automated computer controlled machines to make the cabinet, the cabinet quality will always be of the highest standard. Our machines can work to one hundredth of one millimetre accuracy. 

All models are designed for Australian conditions
In Australia we have all the extremes of environmental conditions. So as a result speakers should be designed to deliver optimum performance levels despite a wide variety of conditions. Our speakers deliver optimum performance at a barometric pressure range of 950-1,030 mbar, temperature up to 50 degrees C and relative humidity up to 95%.